.jpg)
.jpg)
Isomat Multifill 3-Part Epoxy Glitter Grout 2kg + 200g Glitter (Choice of Colours)
Three-component decorative, solvent-free epoxy grout.
The addition of ISOMAT-GLITTER forms a colored, decorative grout that ensures a sparkly result of special aesthetic.
Applied where high mechanical and chemical resistance is required.
Ideally combined with glass mosaic tiles and tiles with high chemical resistance.
Suitable for pointing wall or floor tile joints in residences, clubs, shops, industrial sites etc.
Classified as RG tile grout, according to EN 13888.
MULTIFILL-EPOXY GLITTER is applied to achieve a grout with special aesthetic finish, due to the reflection of light caused by the special glitters ISOMAT-GLITTER.
Furthermore it is used wherever high chemical resistance and mechanical strength is required.
It is ideally combined with glass mosaic tiles and with high chemical resistant tiles.
It is suitable for pointing wall or floor tile joints in residences, restaurants, showrooms, commercial areas, industrial areas etc
Mixing proportion (A:B): 100:7 by weight
Density (A+B+Glitter): 1,35 kg/l at +23°C
Pot life: approx. 45 min at +23°C
Cleaning: in 45 min at +23°C
Walkability: after 16 h at +23°C
Minimum hardening temperature: +10°C
Partial loading: after 48 h at +23°C
Full loading: after 7 days at +23°C
Compressive strength: 49 N/mm2
Flexural strength: 30 N/mm2
Wear resistance: ≤ 210 mm3
Shrinkage: ≤ 0,4 mm/m
Water absorption after 240’: ≤0,02 g
Adhesive strength: > 3 N/mm2 (breaking point of concrete)
Cleaning of tools: Tools should be cleaned thoroughly with water after any work interruption.
Mixing of the components
Components A (resin) and B (hardener) are packed in two separate containers, in predetermined mixing proportion by weight. The whole quantity of component B is added into component A. Mixing of the 2 components should take place for approx. 3 minutes, using a low revolution mixer (300 rpm). It is important to stir the mixture thoroughly near the sides and bottom of the container, to achieve uniform dispersion of the hardener. Next, the glitter ISOMAT GLITTER is added, 10% by weight of MULTIFILL EPOXY GLITTER (Each 2 kg package of MULTIFILL EPOXY GLITTER is mixed with one package of 200 g of ISOMAT GLITTER) and continue to stir until the glitter is uniformly dispersed in the mixture.
Application procedure
Pointing of the tile joints The resulting mixture is gradually poured in the dry and clean joints and it is spread using a rubber float in a diagonal direction to the joints, in order to fill them completely and to remove the excessive material. Cleaning of the tile surface The small quantity of the epoxy grout that remains on the floor tiles surface is emulsified by being rubbed with a slightly wetted hard sponge and it is wiped away immediately. Subsequently, the tiles surface is cleaned again with a soft clean and slightly wetted sponge. The use of lukewarm water makes cleaning easier. For even easier cleaning 10% spirit (by weight) may be added in the water used.
MULTIFILL-EPOXY GLITTER is available in packages of 2 kg (A+B) and ISOMAT GLITTER in packages of 200 g. A and B components are in pre-determined mixing proportion by weight. The container of component B is built in the container of component A.
Shelf Life
12 months from date of production if stored in original sealed packaging, in areas protected from humidity and direct sun exposure. Recommended storage temperature between +5°C and +35°C.