.jpg)
.jpg)
Ardex MVS 95 One Component Residual Moisture Vapour Suppressant 12kg
Suppresses Residual Construction Moisture In Concrete Slabs And Cement/Sand Screeds
Suitable For Use On Subfloors Up To 95%RH
Apply ARDEX Levelling And Smoothing Compounds Direct Without Priming In As Little As 2 Hours
Ready For Use, Resealable And Re-Useable
Suitable For Use On Heated Screeds
Water Based, low V.O.C. Technology
Colour: Blue
Size: 12kg Tub
Coverage: Up To 36m²*
ARDEX MVS95 is a ready-for-use, one-component, water-based, dispersion coating supplied in pre-gauged 12kg units. ARDEX MVS95 is supplied with pigmented blue to indicate uniform coverage and is waterproof when fully cured. ARDEX MVS95 is designed to suppress residual construction moisture in cementitious substrates including suitably prepared power-floated concrete and cement/sand screeds.
ARDEX MVS95 is designed for use as a two-coat system. When fully dry, two coats of ARDEX MVS 95 produce a membrane which can accommodate hygrometer readings up to 95% RH and allows the subsequent application of ARDEX Levelling and Smoothing Compounds without priming.
ARDEX MVS95 can be used on heated screeds that have been installed and commissioned in accordance with BS 8204 Part 1, taking into account the recommendations in Part 4 of BS EN 1264. It is not suitable for use on direct-to-ground substrates without a functioning, structural damp-proof membrane.
Please refer to the ARDEX DPM 1 C or ARDEX DPM 1 C R datasheet for applications where no structural damp-proof membrane exists or the relative humidity is above 95% RH.
Density at 20°C: 1.1.
Open Time: 20 minutes at 20°C.
Walkability and over-coating can be achieved in as little as 1 hour at 20°C and 65% RH.
Drying time will be extended under cool and/or humid conditions.
Colour: Blue.
Size: 12kg Tub.
Coverage:
- % RH (Max relative humidity measured): 90%.
- Minimum dry film thickness required (microns): 150.
- 12kg maximum unit coverage per 2 coat application (m²): 36.
- % RH (Max relative humidity measured): 95%.
- Minimum dry film thickness required (microns): 200.
- 12kg maximum unit coverage per 2 coat application (m²): 27.